激光可使原子显微镜更敏锐

Laser physicists ¹ have found a way to make atomic-force microscope probes 20 times more sensitive and capable of detecting forces as small as the weight of an individual virus. The technique, developed by researchers at The Australian National University (ANU), hinges on（取决于） using laser beams to cool a nanowire probe to minus 265 degrees Celsius ²., ,"The level of sensitivity achieved after cooling is accurate enough for us to sense the weight of a large virus that is 100 billion times lighter ³ than a mosquito," said Dr Ben Buchler from the ANU Research School of Physics and Engineering., ,The development could be used to improve the resolution of atomic-force microscopes, which are the state-of-the-art tool for measuring nanoscopic structures and the tiny forces between molecules ⁴., ,Atomic force microscopes achieve extraordinarily ⁵ sensitivity measurements of microscopic ⁶ features by scanning a wire probe over a surface., ,However, the probes, around 500 times finer than a human hair, are prone ⁷ to vibration ⁸., ,"At room temperature the probe vibrates, just because it is warm, and this can make your measurements noisy," said Professor Ping Koy Lam, a co-author of the research that is published in Nature Communications., ,"We can stop this motion by shining lasers at the probe," he said., ,The force sensor ⁹ used by the ANU team was a 200 nm-wide silver gallium（镓） nanowire coated with gold., ,"The laser makes the probe warp ¹⁰ and move due to heat. But we have learned to control this warping ¹¹ effect and were able to use the effect to counter the thermal ¹² vibration of the probe," said Giovanni Guccione, a PhD student on the team., ,However, the probe cannot be used while the laser is on as the laser effect overwhelms the sensitive probe. So the laser has to be turned off and any measurements quickly made before the probe heats up within a few milliseconds. By making measurements over a number of cycles of heating and cooling, an accurate value can be found., ,"We now understand this cooling effect really well," says PhD student Harry ¹³ Slatyer. "With clever data processing we might be able to improve the sensitivity, and even eliminate the need for a cooling laser."